Steps for Initial Configuration

1. Power On the Unit

   • Connect power and verify the status LEDs light up as specified in the User Guide.

2. Connect to the Configuration Interface

   • Use a USB cable or Ethernet connection to link your PC with the FactoryCore.

   • Launch the FactoryCore Config Tool software (available on the official website or USB provided).

3. Firmware Verification

   • Check the firmware version in the Config Tool’s info panel.

   • If outdated, follow the update procedure (see Appendix A).

4. Set Network Parameters

   • Assign a static IP or enable DHCP according to your network policy.

   • Configure subnet mask, gateway, and DNS if needed.

5. Configure I/O Settings

   • Define digital inputs and outputs according to connected sensors and actuators.

   • Configure analog input types (0-10 V or 4-20 mA) per sensor specs.

6. Set Communication Protocols

   • Enable protocols required for your system, such as Modbus TCP, PROFINET, or custom APIs.

7. Save and Apply Configuration

   • Validate all settings and save configuration to the device.

   • Restart the device if prompted.